(Design Ideas ◆Beginning with 10.0 is the main network of the guest room (the network interface on the wall of the room on each floor), and the network segment corresponds to each floor. ◆At the beginning of 10.1, the guest room is equipped with a network (the network interface on the bedside in the room on each floor), and the network segment corresponds to each floor. ◆The switches on each floor are connected to the core 5500 switches through Trunk mode. ◆Because the number of rooms on the floor is small, it can be considered without the mask of 24 to reduce the broadcast storm. ◆All floor cabinets are installed with two 26-port H3C-S2403TP-EI network managed switches. ◆Enable dhcp-snooping function (if supported) on the floor switch to prevent IP confusion caused by private routing in guest rooms. ◆It can open the port isolation on the floor switch or configure the ACL in the three-layer core to control the network security of the guest room. Ps: The original design idea was to use two 24-port 3600 core aggregation switches to have active and standby network interfaces starting with 10.0 and 10.1. Now it is changed to a 48-port 5500 core aggregation layer, which does not divide the active and standby modes. ◆The wireless on floors L7-L28 has not been installed yet, and the 9th, 10th and 11th floors are currently used as experimental floors. First determine how many APs to install on each floor are most suitable for implementation after making a text plan.
This document includes the following attachments:
International hotel network design (original design before construction).jpg...)
收藏
