(This is an IBM fan control program developed by foreigners, which can control the temperature and speed of the fan rolling by itself. I just Chineseized the interface, and modified the garbled problem. Open and edit the fancontrol.ini file, change active=1, the default is 0, exit, run fancontrol.exe, and select mode as smart to control the scrolling speed of the fan through the program. The temperature control value can be changed in the fancontrol.ini file. According to my test results, if the temperature is 48-52 degrees, the fan speed is 1. When the CPU is used at a reduced frequency, the speed noise of the fan can basically be ignored, and the ratio of the start and stop of the fan is about 1:1. , the CPU temperature changes between 45 and 46 degrees. It would be nice if it could be minimized now. This program is still pretty good through the test of my download tool yesterday and night. According to the above settings, the CPU temperature does not exceed 52 degrees, so it should be no problem. As soon as this program is closed, control of the fan is handed over to the BIOS. The latest version, v018, adds the option to ignore some temperature. The settings of fancontrol.ini: 1: Active=(0,1,2) sets the status of the fan control program, 0 means no control, 1 means allowable control, 2 means automatic control after startup; 2: Cycle=5 sets the detection temperature The time distance, 5 is 5 seconds; 3: MinimizeToSysTray=(0,1) sets the status when it is minimized, 0 means no change, 1 means it is minimized to the system tray; 4: MinimizeOnClose=(0,1) Set the selection to close The status of the program, 0 is closed, 1 is minimized to the system tray; 5: StartMinimized=(0,1) Set whether the program is minimized or hidden to the system tray when it starts, 0 is minimized, 1 is to the system tray ;6: IconLevels=505560 Select the temperature represented by the three colors of the system icon, the first one corresponds to yellow, the second one corresponds to orange, and the third one corresponds to red; 7: FanBeep=11 sets the fan start and stop time, the unit is ms ;8: MaxReadErrors=10 sets the number of times that the reading temperature value is wrong, the program will transfer to BIOS control; 9: IgnoreSensors=PWR,YYY,ZZZ set the temperature items that the program neglects to control, fill in the corresponding name, the program will not be Consider this temperature value; 10: Level=480Level=511Level=554Level=607Level=70128 Set the temperature value controlled by the program and the corresponding fan speed, and control it according to the maximum temperature of each component of the system;
This document includes the following attachments:
TPFanControlv0.62\Chinese patch\TPFanControl.exe
TPFanControlv0.62\Readme.txt
TPFanControlv0.62\thinkpad fan.exe)