找回密码
 立即注册
The路由器OSPFNetwork | 家庭/个人应用 2022-08-25 62 0star收藏 版权: . 保留作者信息 . 禁止商业使用 . 禁止修改作品
OSPF动态路由网络的搭建
1、组网描述
OSPF路由协议是企业级网络中最常用到的动态路由协议,现就以下面一个模拟组网来介绍一下华为路由器运行OSPF的配置和状态,该网络由4台路由器构成,核心路由器通过3个串口分别与下级3台路由器相连。
2、组网图
核心路由器2631A通过串口以PPP方式与2631B相连、以HDLC方式与2631C相连、以X.25方式与2631D相连。路由器各串口以及2631A的以太口处于OSPF的0号区,2631B的ETH0为1区、2631C的ETH0为2区、2631D为ETH0为3区。OSPF正常办公时,网络内任一路由器可PING通网络内的任何一个IP地址。

(The Construction of OSPF Dynamic Routing Network
1. Network description
OSPF routing protocol is the most commonly used dynamic routing protocol in enterprise-level networks. Now, we will introduce the configuration and status of Huawei routers running OSPF with the following simulation networking. They are respectively connected to the lower three routers.
2. Network diagram
The core router 2631A is connected to the 2631B through the serial port in the PPP mode, with the 2631C in the HDLC mode, and with the 2631D in the X.25 mode. Each serial port of the router and the Ethernet port of 2631A are in OSPF area 0, ETH0 of 2631B is area 1, ETH0 of 2631C is area 2, and ETH0 of 2631D is area 3. When OSPF works normally, any router in the network can ping any IP address in the network.)

[下载]16155583116.rar




上一篇:弱电资料
下一篇:华为3COM全系列产品规格参数参考手册V2